Item No. Lexuniverse balance Fit-K / TOKYO BED
Size: W180 x L195 x H37 cm
Based on the concept of "creating comfortable sleep", we followed the traditional way of thinking.
Soft type mattress “Balance Fit”
Sleeping position
In a standing position, the center of gravity of the body is located around the second sacrum. Ideally, the center of gravity should be close to the same position when sleeping, and if the mattress is too soft, the center of gravity will be centered on the buttocks, which are the heaviest part of the body. The Balance Fit mattress has been adjusted to slightly lift the buttocks, creating an ideal sleeping position.
Center of gravity
A mattress that is too soft will cause your buttocks to slump, preventing you from achieving the ideal S-shaped sleeping position and shifting your body's center of gravity, making it difficult to turn over. By making the center of the mattress a little firmer, the center of gravity is brought closer to the ideal sleeping position, making it easier to turn over (rotational movements).
Ventilation humidity control
We used hygienic moisture-controlling materials to match Japan's hot and humid climate, as well as the moisture from sweat during sleep. Protects your skin from dryness while reducing the discomfort of sleeping due to moisture in the bed.
Body pressure
Helps improve sleep quality by reducing frequent tossing and turning due to pressure during sleep. When sleeping on your back, our basic soft type concentrates body pressure on your buttocks, whereas with Balance Fit, the excellent soft feel improves body pressure dispersion, and the body pressure is centered on the buttocks. (The center of surface pressure) also moves from the buttocks to the upper body, making it easier to turn over in bed. Sleeping on your side also reduces pressure on your shoulders.
[Waist reinforcement/edge reinforcement]
Uses a 7-inch (approximately 18 cm) high 9-roll pocket spring. The lower back is equipped with springs with a wire diameter of 1.2 mm to reduce the fall of the lower back, and the head, shoulders, and legs, which carry less weight, are supported by springs with a wire diameter of 1.0 mm to maintain an S-shaped line. In addition, the edge part uses a spring with a wire diameter of 1.4 mm to reduce the fall of the edge and widen the effective area. It provides a soft yet stable sleeping experience.
